Over 15,000 experimental and LSA aircraft already fly with Dynon glass panel products. Based on this success, the EAA, FAA, and Dynon partnered to gain FAA approval for the installation of Dynon’s EFIS-D10A in type certificated GA aircraft.
Dynon’s first STC’d products are the EFIS-D10A and EFIS-D100. The EFIS-D10A is a full 4” Primary Flight Display. This product features attitude, airspeed, altitude, turn rate, inclinometer, g-meter, up/down timers, clock, and voltmeter. Battery backup provides power in event of aircraft electrical system failure. Other optional capabilities include angle of attack, magnetic heading, OAT, true airspeed, winds aloft, and density altitude.
Weight and Dimensions
|Dimensions:||4.09”W x 3.39”H x 7.64”D|
|GPS-251 for EFIS-D10A:||6.7 oz|
|EDC-D10A Remote Magnetometer (optional):||3.6 oz|
|Backup Battery:||6.4 oz|
|OAT Probe (optional):||2.6 oz|
|AOA Probe (optional):||5.7 oz|
|Wiring Harness (optional):||9.6 oz|
|Wiring:||D-25 male connector|
|Plumbing:||1/8” NPT (female) each for pitot, static and angle of attack|
|Audio:||Alarm signal for input to intercom or audio panel|
|Voltage:||10 - 30 Vdc|
|Power:||13 watts normal operation, 17 watts (max) if internal battery is charging|
|Temperature:||-22 to 122 F (-30 to 50 C)|
|Airspeed:||20 - 325 knots indicated|
|Altitude:||-1200 to 30,000 Feet|
|Attitude:||Automatic recovery from rates greater than 150 degrees per second in roll, pitch and yaw. In-flight start capability.|
|G-Meter:||-10 g’s to +10 g’s|
|OAT:||-40 to 140 F (-40 to 60 C)|
HOW TO PURCHASE YOUR EFIS AND STCThe EAA's STC specifies out a Commercial Parts List, specifying part number 102778-000 (EFIS-D10A EAA Sales Kit), which is the super-set of acceptable components for installing a Dynon EFIS in eligible aircraft . This part is not orderable itself. Per the Instructions for Continued Airworthiness (P/N TJJ-MAN-01) for the EAA STC, some components are required, while some are optional.
Mounting Accessories, 100351-000; Short 7/64 Hex Wrench,100556-000)
100096-000: Dynon Internal Backup Battery for D10/D100 Series
102827-000: Dynon GPS-251 GPS Receiver/Antenna Module for D10/D100 Series
100433-001: Dynon OAT Probe for D10/D100 Series (requires EDC-D10A)
100141-000: Dynon AOA/Pitot Probe, Unheated
102832-000: Dynon Simplified Wiring Harness for D10/D100 Series w/ GPS-251 support
100024-000: D10 Series Flush Mount Bracket
102813-000: AOA/Pitot Mount Bracket (note that this bracket was intended for use with Vans RV series aircraft. Although approved under the EAA STC, it may require significant modification for use in other aircraft)
Although eligible EFISs and accessories are bought from Dynon and its dealer network, the STC itself is owned and distributed by the EAA.